The Top Companies Not To Be Keep An Eye On In The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit but it's still eye-catching. It's not the most luxurious car in its class, but it's a relaxing and civilised drive.
We often receive requests from Coded Car Keys to replace peugeot key fobs. No matter if the issue is ongoing or continuous these tips will aid.
Water Damage
If you accidentally drop your fob in a puddle or splash it with water while kayaking, swimming canoeing, rafting, or canyoning, it's most likely to be damaged by water. Keep your key fob in a dry bag every time you are outdoors or engage in activities that could expose it to large amounts of water.
You'll also want to make sure that the fob is dry prior to opening it and reusing it. If you notice any odors emanating from the fob such as an industrial-type smell or a sour taste like windshield washer fluid, this is another indication that it's been submerged in water.
A circuit board that's damp can cause the battery to lose its charge, or even explode. If you can pull your 308 keyfob out of the water and turn it upside up and shake as much water as you can prior to opening the casing. Take the battery out, and then wipe the circuit board down using a cotton swab that is dipped in 90 percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system might be unable to function could be due to the battery of your coin is dead problems with the receiver module signal interference, a faulty electronic chip. If none of the above are the reason, you may try resetting your system by disconnecting the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology which allows drivers to start their vehicle from an extended distance, which allows them to warm up or cool down the car before entering. This feature is extremely useful, especially during winter's cold and chilly months. However, sometimes the remote start system ceases functioning due to a variety of reasons, including a dead coin battery.
A coin-shaped battery that is located inside the key fob will last a time of two to four years, depending on how often it's used and the location where it was purchased. The date for use-by is typically written on the package or marked in the manual.
If the key fob has stopped working after being exposed to clean tapwater, remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob has been exposed to soapy or salty water, it may have caused the chip to be damaged. You'll need to replace it.
If you're unsure whether the battery is damaged You can test its voltage with a multimeter that is connected to both the terminals plus and minus. If the voltage is lower than 12-13 volts it is time to replace the battery. If you want to, you can try to reset the on-board computer by disconnecting the 12 volt battery for a few minutes and reconnecting it in reverse order (positive cable first, then negative). The engine should now begin.
Faulty Receiver Module
If you don't see the "Key Detected" message, it could mean that your receiver module is malfunctioning. It is the part which sends out an alert when your key fob is activated. It also functions as an alarm and blocks the car from starting without the correct key.
This can be due to a number of causes, such as water damage or just aging. If the electronic chip inside your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was in contact with it. In this scenario you'll need to remove off the battery and clean it thoroughly with isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.
If G28 persists it is recommended to see the local Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the issue and fix it.
Losing your Peugeot car keys can be an incredibly stressful experience. However, a professional auto locksmith can fix the issue in a matter of minutes. They can program your car and cut a brand new, working key for you. Find a locksmith in your area.
Electronic chip malfunctions
The electronic chip that is in your Peugeot 308 key fob is a very crucial component of the remote control system. If it is damaged, your car might not start or you may receive a message stating "anti-theft active". In this scenario, the only solution is to replace the key. Fortunately, professional auto locksmiths can provide the service in the shortest time.
The chip in the key fob of your Peugeot 308 could be damaged due to different reasons, such as sweat, water damage, or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it needs to be cleaned right away. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. The battery should then be allowed to fully dry.
Sometimes the key fob may stop working because of radio interference. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects in the vicinity. It is recommended to visit a Peugeot dealer in the event of this issue.
The Peugeot 207/308 Key Fob is delicate and requires particular care. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Disconnect the negative cable before the positive.